Trips and parking with axle load

The Trips and parking with axle load report provides information about vehicle movements and parkings, supplemented with axle-load indicators. It is intended primarily for trucks and allows you to compare routes, mileage, and trip duration with the minimum, maximum, and average load values.

Load data helps monitor vehicle operation and identify possible overloads. The permitted axle load depends on the vehicle’s type and design, the number of axles, and applicable regulations.

• Status — the object’s status: Movement or Parking

• Beginning — the date and time when the movement or parking began

• End — the date and time when the movement or parking ended

• Dur — the duration of the corresponding trip or parking

• Distance (km) — the distance traveled during the trip; no value is displayed for a parking

• Start — the movement start address or parking location

• Stop — the movement end address; no value may be displayed for a parking

• Coordinates — the coordinates of the trip’s start and end points or the parking location

• Average weight — the average load recorded during the corresponding event

• Weight (min) — the minimum load recorded during the trip or parking

• Weight (max) — the maximum load recorded during the trip or parking

• Trip type — the trip category determined by the system or the object settings

Addresses in the Start and Stop columns are displayed as links and allow you to open the corresponding locations.

The following summary indicators are displayed below the table for the selected object and period:

• Total odometer — the total distance traveled by the vehicle

• Move Time — the total duration of all movement periods

• Parking Time — the total duration of all parkings

• Average Speed — the object’s average movement speed

• Max Speed — the highest speed recorded during the selected period

• Fuel consumption (by norma) — estimated fuel consumption calculated using the configured rate

• Fuel consumption (by sensor) — fuel consumption calculated using sensor data

• Average l/100km (by norma) — the standard average fuel consumption per 100 km

• Average l/100km (by sensor) — the actual average fuel consumption per 100 km calculated using sensor data

The Parkings and Tracks options are available at the top of the report:

• Parkings and Tracks selected — displays the complete sequence of events

• Tracks selected only — displays movement periods only

• Parkings selected only — displays parking periods only

Select or clear the corresponding checkbox to show or hide an event type.

Compatible equipment that transmits axle-load data must be installed and configured for the object to display the average, minimum, and maximum weight. If no data is received or the relevant parameters are not configured, a dash or no value is displayed in the weight columns.